MITSUBISHI MATERIALS CORPORATION
BACK

TAW

NOTES ON USE
INSERT INSTALLATION
  • Loosen insert screw of holder to install insert.
  • Mesh the insert serration to holder grooves.
  • Fasten the clamp screw using the provided torque wrench while holding rake face of the insert lightly with your thumb. (Figure 1)
  • Check that there is no clearance between the insert bottom and holder flute end. (Figure 2)
Figure 1Figure 2

NOTE ON INSERT REPLACEMENT
  • Clean insert guide grooves by blowing air before installing a new insert.
  • Clean the “slit” underneath the insert on the holder with the provided shim plate.
  • Use the provided anti-seize lubricant for lubricating the threads of the insert screw.