面铣刀 >FP590 >FP590L0514Q

面铣刀

FP590
（铸铁大进给加工用）

FP590L0514Q

产品信息

  • 最适于铸铁精加工
  • 多刃设计，可实现高效加工
  • 大进给加工用
  • 刀具更换容易
  • 使用11°正角刀片

实际产品与显示图像存在不一致情况，敬请留意。

图   [放大 ]

图   [放大 ]

尺寸 (Unit)
Metric Inch
mm in
microns * microinches *
N lbf
deg deg
MPa psi
N/m lbf/in
Nm lbf-in
kg lbs
rpm rpm

* Only ADJAR,ADJRR
切削方向 L
库存
长度单位 M
DC 125
DCON 38.1
BD 135
KAPR 90°
L8 7
LF 63
KWW 15.8
APMX 0.5
GAMP +5°
GAMF 0°
WT 4.2
Peripheral effective cutting edge count: ZEFP 14
2D 模型 (DXF)
CAD数据名称 下载
FP590L0514Q
CAD
Disclaimer
Be sure to read the following before downloading the data or file you selected. Please understand that if you decide to proceed with the next step it will be at your own discretion and responsibility.


As far as allowed by law, Mitsubishi Materials Corporation shall not be held responsible in any way, either manifest or implied, including but not limited to legal warranty against defects, warranty of merchantability, warranty of fitness for a special purpose, or warranty against infringement of rights.Therefore, in the event that the above-stated download of the selected data or file results in the customer suffering a loss of data or damage to a computer or system, Mitsubishi Materials Corporation shall not be held in anyway responsible for said loss or damage. Further, the contents, including data and files, may be modified or terminated without notice, and Mitsubishi Materials Corporation does not warranty that any posted contents are error free.


If you agree to this disclaimer, please select “Agree” below.
Thank you for your understanding and cooperation.

库存

:标准库存品
:预订生产品
:目前为标准库存品，但将来会被新产品替换的产品
:特定代理店库存品

  • 推荐切削条件

  • 另购

  • 旋转刀具用刀片

  • 零部件

返回页面顶部

点击本页上的“同意”按钮，即表示您同意使用cookies并接受我们的隐私政策。 本网站使用cookies来改善网站，提高顾客的使用体验，分析网站的使用状况，以便于我司的市场工作。详情请看《 个人信息保护方针 》。